Profiles
	Spindle speed for cutting
	Cutting feedrate in units/min		Vertical down Z moves will use this rate
	Nominal material thickess		Table top is Z-Zero instead of material top
	Percentage of material thickness to cut		Ramp instead of Plunge
	Cutting bit diameter, set before creating cut lines		Ramp angle limit in degrees. 0 is no limit, max is 44
	Width of tabs, allow for bit diameter		How much material to remove in a tab
	Height above material to rapid safely
	Safe size of material on X
	Safe size of material on Y
	Sets direction of cuts
	Use multipass for hard materials		Depth of cut for each pass
	Generate a 3D cut path over a 3D object		Percentage of bitdiameter to step over
	Launch Gplot after generating G-code