Separate names with a comma.
Some features disabled for guests. Register Today.
A star configuration is where each connection has it's own wire back to a main connection or hookup point. As opposed to a jumper or series...
Rut Ro Raggy...I think everyone has figured out that Boo is the real talent in the shop o_O
Hi John, Yeppirs...Pour the slab...someone told me that I couldn't get the job done if it wasn't really stiff... ;) I wish I could say it was...
Thanks guys and gals, I am adding some braces in between the bottom plates to make sure I don't get any sag when I pour the slab. of course Boo...
Probably wouldn't hurt to mention that if you are running multiple independent power supplies, like I am with Ultimo, that the same rule applies...
Hey Folks, Been a good day today. I managed to get the rest of the V-slot installed and got my alignment caps all built for setting my studs...
I believe you have to have a parallel port to run the Mach3 software. I have seen that 4 is in Beta but I have heard rumors that they still have...
I still have one of my old AT style computers with a real parallel port that I can dedicate and the controllers for that would be really cheap...
Hey Tweakie :) Since you guys were talking about it here I thought I would ask your opinion on the different freeware cam systems. I was...
Hi All, Sorry I haven't posted much this week. My other project required my attention for a couple days. I am happy to report though that I...
The router I am using for Ultimo has a 12.7 mm (1/2") collet and two adapters. one for 3/8" and one for 1/4" bits. Although it is probably not...
Thanks John,,, I still have a bit of work to do on the frame. I have to get my top piece drilled and cut then I will add some pieces to the...
LOL Thanks Tweakie. And NO I don't do windows ;) Yes Boo is a wonderful helper. Today I needed a stationary reference point while I was getting...
Nice Build Robert
Hi Kids and Kiddettes, Hope you all had a good weekend and a great Mother's Day like we did! LOL @ Kram242...Thanks for the kudos and ME TOO ME...
Thanks Tweakie. Boo and I will be sure to keep the vacuum on while we are cutting and drilling just to be safe. I am being lazy today but I...
Hi All, Man the sawdust has been really flying today. Good thing Boo makes a terrific dust mop ;). Thanks for helping keep me straight buddy....
OUCH!!! Our first mishap....I took the stack of panels off my bench vise and set them aside to start a new setup for cutting the holes for the...
Woot Woot the panels are cut. Ultimo should be standing on his own three feet tomorrow. Stay Tuned.....
Smooth like butter!! I changed my layout technique a little and the new jig works great. I should have no problem finishing up the other two...
