Separate names with a comma.
Some features disabled for guests. Register Today.
Once you try them you will never go back to flute type countersinks for soft materials. They cut so clean and fast it is unbelievable. The...
Never mind I just saw your post about the Ebay kit
Say, Teflon4, where did you get those linear rails? You've addressed a couple of the shortfalls I really didn't like about the C-Beam Machine,...
Cody: The NEMA 24 motors and power supply in the Openbuilds store are pretty good, and motors are rated at 2.8A. I run mine at 3 amps with no...
Teflon4: This is the type of countersink you need for aluminum. It is amazing the quality of finish you get from these things. It's just a cone...
Another bump stop idea. [ATTACH]
Rick: Yeah, those ideas would work, but I was thinking of something much smaller and riding along the inside of the c-beam, against the back of...
David: Ok, I think I got it now. If Zmin is set to zero, it will stop when Z gets to zero no matter what overcut you have set. If you set Zmin...
Gray: Yeah, I think half inch would be much more suitable for the 1000mm actuators. I've been thinking about a device that would slide along the...
As far as the lead screw goes, I checked the diameter with a digital caliper along the whole length of the screw and it was 7.80 to 7.85mm...
Hi Crew: Just though I would drop you guys a line to point out some, well, flaws shall we say in the C-Beam machine design. Don't get me wrong,...
Cool, well all I can say is, keep up the fantastic work...
Cool, thanks for your opinion. I like GCodeSender as well, was trying out GRBL Panel, but there are a few things I don't really like about it....
Sonny, I did not get a recommendation from you as to which GUI (IYHO) was the best and most stable... Or is that a conflict of interest?
So, all good information Guys, but: I thought anything within a comment section was supposed to be ignore by GRBL. (or any code, for that...
Just ran another test, better results except for two things: 1. Holes seem to be coming out a bit small. I am using 1/8" hardboard for test...
So, still messing around trying to get this to work.. NC Corrector crashes with a "Divide by Zero" error every time I load a file. Doesn't seem...
All right guys, thanks. Good to know. I will have to be much more careful when generating g-code drawings from now on.
Don't you guys have anything better to do? ;)
David: Yeah, I told you I was a noob. There's probably a lot of artifacts in there buried inside the model that are not visible. I know I was...
