Separate names with a comma.
Some features disabled for guests. Register Today.
You wouldn't happen to have any code to make that circuit work would ya :p If I'm right it would work by converting the v ref from mach3 0-10 vdc...
Sweet! I will try and design a pcb :)
Try checking this out and if you need help to make the pcb I have the material on hand. If anyone that feels they can program a attiny to do this...
A 12-14 vdc power supply @10 amp rating will be enough As for the VFD they are designed to work with AC induction motors. These are completely...
It's a servo motor tester made in house. I have not tried myself to get mach3 to control the speed but I'm sure there is a way, now u got me...
No prob :)
Hate to say it but yes DHL is disgusting at service and look out for fee's broker and duty :( learned the hard way
@JCPhlux Your custom plates and care package is on its way :) Same time frame as before
@oni305 Your plates are headed your way again. I went today and complained and they shipped it for free at their cost, but they refused to cover...
Ok your good to go then :)
@chip_breakin Shipped ;) hope it helps As for money lol, what's money between friends. Pay it forward ;)
LD2X has sold out on Openbuilds A new version the LD3X will be made in a lot of ten with the following changes. -Power indication LED -Relay is...
I do not mill Garolite as it's hard for me to get and Canada has marked it as un-safe to mill. The spacers for my nema23 motors are made from...
I'm going to mill them ASAP so I don't forget, then mail via stamped mail. Start a conversation with me and send your full mailing address
It is 6.78mm wide and 4.85 high ;) plenty of room
I did think of that but I would have needed to make two different tension designs so I did my best to allow room. You would need a stubby Allen...
Yes six and yes to the belts, I have not milled anything but do like it :) [ATTACH] Here I was test fitting it and I think it's 5 mm wide it...
Oh! Ok now it's clicking I will mill a set fast for ya how many do you need?
Warning ! Any OX AI files from previous posts have not bin updated as of yet and will not work do to miss spaced holes. I will be updating the...
What files have you got?
