Separate names with a comma.
Some features disabled for guests. Register Today.
Did you watch this video from ThePaintballGuy? His settings are in the description, your settings look close to his [MEDIA] Also I've read that...
I have seen this with wheels that are set too tight, does the carriage move smoothly and easily with the belt removed? Can you (with some thumb...
Dlh, acceleration is setting $120, 121, 122 (x,y,z) the default is a conservative starting point. For example on my ox I have it set for about...
Personally I drill mine out for M5 Gary
Yes, will not be a problem, the driver will current regulate, higher voltage gets you more speed potential. Cheers Gary
Hi Mari, post your cnc file so we can take a look, could be a post processor issue. Gary
Hi Dlhoulton, Your plunge rates can be double, your feed could be higher as well with such small step-overs. What is your acceleration set in...
Not in the settings, but the little trim pot for adjusting current. Cheers Gary
If you never turned the z axis pot current up then that’s probably all it is. like Dave said if your motors don’t get at least warm, turn the...
I'm curious as to why so long of a cut time, is the project that large? Maybe we can shave off many hours by optimizing your machine and cam?...
Hi Ryan, you are using the "track nut and set screw" setup to clamp the belt down? Some people have put a thin strip of metal or plastic like a...
Typically the dia is the max dia of the V-bit, not very important unless doing deep carves. example from Freud, the capital "D" [ATTACH] Cheers Gary
Hi Tom, so you are measureing 24V? until you put a load on it, aka the blackbox? double check 24v pos to pos and neg to neg, also maybe try a 24v...
Hi Tom, 1) Do you have the Openbuilds PSU? make sure the black AC wire is on L, white on N.. and tight Make sure the input selector switch is set...
With ESTLcam you can click on any line and start from there, the visualizer updates after clicking so you can see where the tool will go. Came in...
Hi Paul, “Motor makes terrible noise” Almost always a wiring issue, broken or loose connection, take a real good look. Cheers Gary
Typical for a belted system is 1/8 micro, any less gets a bit noisy and not smooth. Are you using typical 20tooth pulley? If yes, then it’s...
To Add to what Rob said, make sure you don't have your wheels too tight, this will lead a more backlash than typical. And I recommend Dual belting...
