Separate names with a comma.
Some features disabled for guests. Register Today.
Is there a way to mark centers and call out the hole size in the cam? some cam programs can do this. Gary
On Estlcam preview they don't look like circles and they are broke up into segments. Cheers Gary [ATTACH]
Post your settings a test file here, could be settings or the drawing might be turning circles into hexagons for example. Cheers Gary
Try a different control software and see if it is the same. UGS panel is easy to get and configure. Gary
Powge is the best for this, but I cant find 16 tooth with 1/4", I can find 6mm shaft. Might have to go 20-24 tooth, at 16 there isn't much room...
You will be using 24V, steppers are rated by current and inductance, voltage rating is related to inductance and current, lower inductance is...
Check that your accel and velocity are set the same for both axis. Increasing the accel is probably most overlooked and important, takes testing...
O-flute bits for acrylic and aluminum.. the dial references are speed settings for the 611 dewalt router and the Makita 0701 Cheers Gary
IMO it will be too heavy and powerful for a lead1010, you will never use the potential of this size spindle, 1/4" bits are plenty big for these...
I did at one point pick up 3mm drills for cnc, but for this I would use something like this from amazon or this maybe even better Gary [ATTACH]
Spot drill with the cnc then manual drill the rest of the way. Gary
With reduction like this project the resolution is increased. 8mm lead screws like these have a direct drive resolution of 8mm/1600steps at 8th...
Post your $$ settings here, many people get tripped up with $4=1 (needs to be or it will never move) Take any limit, coolant, door, or home...
looks like a line (just a dent) that happens when I run the wheel into an end plate, does it go all the way through? 2169 is real fast! Gary
A bad connection somewhere on your motor cable. Are you missing steps? Cheers Gary
Looks like the other end of the chain is too far away, you can mount the end on the table at almost the mid point of the travel so the chain is...
None, just turn the current pot up. I would start with this, as maybe your machine is now a bit dirty and the drag is causing the issue. Also...
You can remove it, I removed both of mine and replaced the cable with shielded cable and grounded the chassis. It only emits when going through...
The stock thing on the Makita router cable is not a choke it's a security device. Cheers Gary
Just disconnect the hard limits, unnecessary complexity. Otherwise.. Shielding and grounding and 10uf caps are in your future Cheers Gary
