Separate names with a comma.
Some features disabled for guests. Register Today.
Kinda Dumb maybe, but estlcam supports tool changes and doesn’t slow down on trochoidal or large (file size) 3D jobs. Gary
Yes can do G-code only for sure. I have also flashed my BB from GRBL to Estlcam (xpro4 preset) and back to GRBL and then back to ESTLcam with no...
One of the four wires has a bad connection. Check every connection, could be a broken wire or bad solder joint, or loose connector. Gary
Hi Alex, as long as the z probing was setup correct and the offset is showing correct on the coordinates you do not need to move the tool down to...
Hi djbart, use a multi-meter and check the voltage of the BB signal, should read 5V DC (at the "toolhead") when the spindle on is commanded. You...
Something like this? Wish Openbuilds carried it!, it's hard to find. Probably cheaper to use 2080 from Openbuilds. Gary
Hi CA, there is Diameter, Pitch and Lead, the dia is 10mm in your case, 2mm pitch this is the per thread or per start pitch, and you can have...
Hi Steve, Yes you can use the BB on an OX (My Ox is using a BB), the configuration is not difficult to do even without a pre-set, we can help you...
Looks good!
This little compressor doesn’t use too many amps but I’m on a 20A
I didn’t use a ton of oil just started with a small squirt and another about half way through. The air blasting blowing most of it away anyway....
Yes, could rough it out with tablesaw and cnc to spec?
Could just use a router or router table, cut manually Gary
Totally agree, I just ordered the ubiquitous mist/air setup on amazon, hoping to incorporate it into my dust shoe, my vac isn't strong enough to...
A "bit" embarrassing (after the post above) but also a milestone for me, I was able to slot cut yesterday! Using a 3mm O-flute, 500mm/min, 0.5mm...
Best makita collet first 1/8 and any other size is probably elairecorp.com/site/makitaroutercollets.html?imz_st not cheap and shipping hurts too...
Install the drivers ? <link to the drivers Cheers Gary
I've never gotten shallow slots to work without welding aluminum to the bit, my machine isn't stiff enough to push through at low RPM. With...
Hi Rob, post your GRBL settings so we can see whats up. If cutting aluminum make sure no chips are getting on the board, and clean it with...
Hi Travis, looks like your router power cable is in the cable chains? Might be the cause. Either string it outside and up out of the chains or if...
