Separate names with a comma.
Some features disabled for guests. Register Today.
To cut wood with a laser you really need an "air blast" to clear the smoke, and more than 1 pass ends up with nasty char on the edges.. my...
Gaming type desktop or laptop? did you check USB suspend setting? Could it be thermals? what motors are you driving and how high do you have the...
Hi Oliver, best place to ask questions is on the BlackBox forum page, BB is pre-loaded, did you install the drivers on your PC? follow the...
Hi Ricky, welcome to the forum! you will get faster help with a question if you post the question in the section of the forum devoted to the...
Hi Richmond, halfway down this page you will see instructions on setting motor current. For sure get a cooling fan blowing on it, and check those...
Hi Peter, Looks like a loose setscrew on the pulleys Cheers Gary
It might be the aluminum is not an easy to machine alloy? 6061 is common for its easy (easier than others) machining properties. Also that looks...
Hi Mateusz, For safety you should get a three wire cable/plug (hot-neutral-earth) for that PSU. Then the chassis of the PSU will be protected and...
Ok, well they usually are on the bottom, and should be adjusted till it tightens up the wheels, looks like they already adjusted maxed out? I can...
Hi Urko, Looks like most of it is from the wheels under your gantry being loose, adjust the eccentric spacers, so they are not loose. Cheers Gary
The video's are good, the version doesn't matter too much, if you have any questions just post on the forum and we will help. Christian Knüll...
Steppers need stepper drivers so it would depend on what driver you have, higher voltage will get you more speed, and 24v is typical for nema23....
I used the Xpro config on mine and have had no issues with pin-outs, limits or spindle for example work correctly. Uno probably fine as well, I...
I have been using ESTLcam on BB for a while now, works great, treat it as an XPro when you flash it. Cheers Gary [ATTACH]
Hi Bruce, Please post the cnc file here so we can help, what programs are you using? Is this the first 3D project you tried? has this happened on...
Hi Doug, Have to look at the dip switches to see what the current is set to, also make sure the low current at idle is active. (sw4 on) How do...
Are you sure its not 25mm? 25 would work even if it was 26. I actually have some 10mm wide belt just like that, I use at work, I looked up the...
Try this? Ebay link hard to say without a side shot and accurate measurement, couple different standards out there. Are the belt teeth flat on top...
Hi JLM, it's not usart, it's GRBL program on the arduino, digital pinout pulses, for step pulses and direction high/low, that's what typical...
Hi JLM, you can chain up as many (to a point) of the step and direction wires to multiple drives as you need. you can see in this pic of my drive...
