Separate names with a comma.
Some features disabled for guests. Register Today.
Hi Jeremy, what part of nz are you from? I have a working Ox in Auckland if you wanted to see one up and running to help you along with your...
I wish i did but the builder requested that I not take any photos while I was installing a Mach3 controller to his build. The build made good...
I was really impressed by the formply gantry I saw built in NZ. Really nice balance between weight and stiffness. Looking forward to seeing more...
Hi Guys... I have finally started working on my own Ox variant and wanted to check no one else has already started using the name Fox or Foxy...
I like to use a square drill pattern near the outer most limits of the travel. Drill a tiny spot in each corner and then measure the diagonals to...
Robert makes the spindle kit himself and might be able to add it on to the kit you want to order. I HIGHLY rate his work and can recommend a...
oh I just clicked that it is a stock ox kit.... I already have one of those so I might need to get a second kit off you with your custom work as I...
Can i call shotgun?!
@Robert Hummel what about a sand/glass bead blaster? I am happy to buy a "raw" kit and test it out as we have a blaster at work. Have you ever...
Count me in for a full set in the next batch too!
Don't worry about it till you see bad results repeatably in the same spot from your cut parts.... Often tiny bumps will not be notable in the...
An outrunner is: lighter fairly cheap to build Speed control is also very nifty for getting the right spindle speed to feed (chipload) An ER11...
@Pat Heppner and @Duane I could ship two short sticks to one of you and that person can send the other bit on? I have a mate with a mill that...
@Paul Franklin Yes the USBCNC boards will need stepper drivers connected to them. I have heard that the motion is VERY good from this controller...
Hi @greenmonk , Sorry for the delay but I have posted a few photos of my way of mounting the limit kits from OB. Both of the long axis have a...
I will take photos of my limits later today when I get home from work.... For now just a little bit of a teaser .... I did my best to cut the...
about to mill the ends off a big stack of vslot!
I worked it by using the below method motor steps x drive micro stepping/pitch of the belt x # of pulley teeth 200*10/2*20=33.33 Steps per in...
