Separate names with a comma.
Some features disabled for guests. Register Today.
I think this would be an AND gate for this inverted use case? If either goes low, the output goes low. I guess XOR would work too, it just needs a...
Re-home and re-probe. The machine has no idea where it is. And remember, this... ...isn't specific to this situation, but a general...
I’d argue that first G0Z0.2000 should be a G53G0Z-0.2000, but other than that, you say that you set Z0 to be the bottom of the 5/8” part in your...
I just did the same thing this week on a flat part, except in my case it was because when I was setting up the tool table, it was only taking Y...
Some kind of pinch-clamp setup on a piece of steel angle screwed to the side of the z axis rail is how I'd do it.
Would probably be an epoxy and aluminum beams/truss job, but no reason it couldn't be done. Laser tube would likely have to be gantry-mounted,...
Really need to lock the carriage, not the screw. Locking the screw still leaves you with whatever backlash is available as permissible movement.
Might be best to dig that out again if you're planning on going with Mesa hardware. That's really what it seems to be designed for in the CNC...
Definitely agree with this, as far as I can without direct experience. I've seen a lot of places about how smooth and quiet they are. My Ender 3...
Even when the frame can handle it, high speed strategies tend to win out against high torque strategies regardless. At that point it's mostly...
What do you like so much about them? As I recall, there was another discussion around here not too long ago that ended up teasing out that the...
You didn't add any IO modules, which means all of your IO is unprotected and on header pins instead of terminal blocks. Which is A) a fairly...
I agree with your overall point, I'm not a huge stepstick fan either except where portability would be paramount, but I'd probably quibble a...
I'm not sure I'm getting it. The pluggable modules are a nice theory, but none of them really seem super optional for basic functionality, and are...
No worries! Usually when I spot a "specificity" setting like that I'll throw some loose numbers in there just to be on the safe side, like you saw...
Either Slope or Max Stepdown, I guess, only differences I see. Ok, just tested, it is Slope. If you just click the down arrow to knock it down to...
Hmm, odd. Here's mine: [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] The only difference the 1/4" bull vs 1/4" ball is gonna make is the...
Got it. I set it up the same, and a 3D ramp with a 0.1 degree (or less, whatever you want) helix angle seems to be the way to go: [ATTACH] I...
That would be why the entire thing gets redone, then. If you do a rough-finish strategy on the bores, zero stock to leave, and no Rest Machining...
Are you using Rest Machining, and Stock To Leave on the 2D clearance? A roughing op will always default to 0.5mm of stock to leave if you didn't...
