Separate names with a comma.
Some features disabled for guests. Register Today.
Probably sensible. Hard to justify the costs of an oversized place, even when you own it outright, I'd imagine. I'd like to have somewhere in the...
Spotted this in the wild: If it's actually for FCC EMI transmission compliance, and doesn't affect external interference on the computer, you...
I've always watched every single one of Matthias' blower videos! They're so good (and I'm amazed at the balancing he gets with wood). Linear rail...
I've thought about one of these too. They're complex, though, I've never been able to justify the time or cost I'd have to put into one. It's...
Update: original DID output proper signal, I'm just an idiot. Well, I haven't tested it again, but I'm pretty sure it was fine. Whatever, it can...
Oh I did laugh when I read it, just didn't carry over to my response for some reason. Seems like, at 12-24V you have a LOT more leeway than you do...
Pretty sure I have the spades on the NC terminals of the switches, actually. It's trivial with Mesa hardware to switch between the two in the...
Unplug the BlackBox/Arduino USB so it's disconnected from the computer and try again. I found this on my laser- continuity of earth ground and...
Right, I inferred that- you can have a feed hold and start/resume hardware switches, assuming the BlackBox has IO for both, I do on my grbl-based...
That's not the way many of us do it, but it's the way Peter likes it and is technically the safest option. A door plug should be connected to pin...
Interference gets worse the longer the cables- more RF coupling (ie. antenna) and/or AC inductive coupling, more voltage drop (less signal)....
LMAO. Yes. But until machine coords magically vanish, I still say you should try an experiment where you have the option to turn on G53...
I hadn't actually looked into the Teensy 4.1 before. That's an impressive piece of hardware, especially for the size, and I'm assuming all the HAL...
@phil from seattle Is there a good open source 32 bit processor to pull reference designs from? I think the inherent advantage of the 328p is that...
Interesting. Maybe a 7i76e would be an easy build- the IO portion is just some buffers and encoder multiplexing, probably not that difficult for...
You won't get more precision than that without mapping the screws with 1um glass scales anyway. I'd be surprised if they were accurate to more...
Depends how much he wants to get into FPGAs and how much OpenBuilds want to hire a support specialist to give him the time to do so. :D FPGAs are...
That's usually in the post processor, or maybe operation setup, under something like "full Z retracts" in heights or linking moves, not the...
Also, for the record, I've re-applied the gib lock screws, with locknuts, which should help maintain more consistent lash in the system. Some...
All you're doing is loosening and tightening- and you could have a Belleville stack and air cylinder do that part for you as well if you really...
