Separate names with a comma.
Some features disabled for guests. Register Today.
Slic3r by default over extrudes the first layer to aid in bonding to the build plate, which will get you your wide base that you are seeing. You...
The heatsink and fan will be fine, but the lens will be useless. It won't create a very even distribution of light. The deep reflector that the...
That's a difficult question to answer. Put the LED too far away and the intensity at the LCD panel drops and cure time increases (but intensity...
That's a difficult question to answer. Put it too far away and the intensity at the LCD panel drops, increasing cure time. Get it too close and...
Well, you want to block the wavelengths of light that would prematurely cure the resin. For the vat, you can make that opaque if you like. For a...
Cure times will vary with backlight intensity and resin used. A decent starting point would be to find out what the cure times are for some of the...
If you want to start off easy, then just get an LCD and use the daylight curable resins. With the stock backlight, cure times will be much longer,...
Not all eDP boards will work with all eDP displays. Just get this 2KHD 9.7" 2048X1536 LCD Panel + HDMI Audio DisplayPort Controller Board DIY kit...
Yes it will.
Nope. You want the generation 3 or 4 iPad Retina screen. It's much higher resolution, and will work with that adapter board, where the other one...
Well, I've been working on this myself, and you can read about it here: LCD Based SLA Resin Printer As for those monitors, sure they can work,...
I don't think that you can get UV EL panels, but even if you could, the intensity is too low. You would have better luck with the stock backlight...
Ask away. We are all figuring this out as we go along. My progress may be slow, but I'm researching all the time.
No progress. I was sick at the beginning of the week, and now I'm out of town on business through Friday. Also, selling the house is putting a...
I would buy your first, even if it's a kit. With the kit at least, you get to see how it all goes together. Building your own can get expensive...
Same power as the LED in the Wanhao D7, which is why I picked it. I was tempted to pick up the 50W versions too, but they were a lot more expensive.
Nylon is not what I would start out with. PLA is a good starting point to learn with to get a feel for the machine. It's cheap, moderately...
Other than powering them up, I haven't done anything more with them. I'm a little strapped for time right now, as we are getting our house ready...
The Wanhao Duplicator i3 is pretty highly reviewed, and has a stronger frame. Unless you have a very specific need for dual extruders, I'd just...
Florian, he's looking for 0.01 inch repeatability. I'd think that would be very doable based on the equipment he is using.
