Separate names with a comma.
Some features disabled for guests. Register Today.
Basically, NanoDLP works just like Repetier/Pronterface/Simplify3D where you feed it an STL/OBJ file, and it slices it up and generates the gcode...
The Wanhao is backlit with a powerful UV LED array, so it makes it a little different than this, and cure times will be vastly different. A closer...
The 5.5" screen is smaller than the initial design, which used an iPad 3/4 screen at 9.7" As for brains for the 5.5" setup, you could most likely...
The CNC shield won't be able to handle it, as it doesn't have connections for the thermistor input and the heater output. For this, it really is...
Well, looks like you have the controller/driver situation sorted out. As for the extruder mount, I may not have done it the best way. What I did...
No real changes as of yet to the original design for the iPad screen version. The 5.5" 2K screen and 15.6" 4K screen versions will just be bigger...
@fantasy2, looks like the polarizer is 0.05mm thick
You will most likely want to use the spindle enable pin, which you can find on the right side of the board labeled SpnEn [IMG] Now, I have no...
Yes, FEP film will be used. I think I have about 10ft square of the stuff at 0.005" thick. You can get large sheets of the stuff from McMaster Carr.
I'll get a measurement tonight (if I remember :) ), but I think it's about 0.1mm thick. Mounting tabs are 0.8mm +/- 0.2mm from the front face...
Well, the link was just for filament. Anyway the same question as earlier still stands. Why buy the pen, when you can get a more accurate,...
Looks good, if not a little overkill. The ballscrew is HUGE. The way the numbers work is like this: for a 3205 ballscrew, the 32 designates the...
Doesn't look like it was intended to support anything more than 1080p, but that may have been a limitation they imposed because of the same...
If you don't count the LCD, it's adapter board, and the computer to drive the LCD, then I've put about $350 into it so far, most of that being...
Lol, no. Nothing printed yet. This project has fallen to the evil ways of feature creep (where the designer can't leave well enough alone with the...
I'm sure there are other options, but an LG 24UD58-B is 24" diagonal at 4K for $299 here in the US.
If you had to lift that much weight, I think I would resort to using either SBR12 or SBR16 supported rails (ground cylindrical rods with mounting...
@nano, you are a bad influence :p. I apparently can't leave well enough alone, and certainly can't finish what I started before getting side...
Any LCD will cure daylight curable resins, so yes, these can be used without modification. The use of more readily available UV cure resins would...
I'm not using Marlin, but the Smoothieware equivalents are: default_feed_rate -- 4000mm/s (this is obviously limited to slower speeds in the...
