Separate names with a comma.
Some features disabled for guests. Register Today.
You can run a separate cord, or you can tie into the AC input for the DC power supply. Same difference. I chose to wire it to the AC input on the...
Well, only took a little more digging. I present to you, an 8.9" 2K LCD with HDMI interface 8.9 inch 2560*1600 WQXGA 2K LCD Module Screen Drive...
It's quite possible that it's the LCD from the Kindle Fire HDX 8.9". All the numbers fit. What's really nice about this display is that its about...
Heater is controlled through a solid state relay. Input signal for the SSR is connected to the same port that a DC heat bed would be connected to.
You mean, using a 3D printing pen like a 3 Doodler? Is there a specific reason you would want to go that way rather than make a more traditional...
The big advantage you would see from a change in heater (especially if you increase the wattage rating of the heater) is faster heat up times. I'm...
I've seen that one around before, and a coworker has one on preorder (not sure when he will be getting his). The print area is pretty generous and...
Have you tried glue sticks? ABS slurries? Those will help some, but might not be the final solution. Success at this point with ABS is more likely...
Personal CNC Mill - Tormach PCNC 440
Cooling wouldn't be needed if you are just replacing the stock LEDs with blue ones. The amount of power consumed isn't changing, so the heat level...
With a small enclosure like this, I don't think it matters where you plumb it. You can try an 80mm PC fan, but it may not generate enough static...
Rather than duct the air outside, and as you rightly said, lower the air temperature as a result, it may be better to just recirculate the air...
Looks like it's coming together nicely. Any chance of seeing some other shots of the calibration cube? I'd like to see how the vertical surfaces...
It's certainly doable. It's a little risky though, with the LCD being large and thin there is a decent risk for cracking the screen and making it...
Going with the bottom up array of LEDs will allow you to run at much higher energy levels than you would for even a blue backlight. You also have...
The Sharp panel that I have has no aluminum backing. There is a frame around the perimeter, but that's it. This one should be much easier to get...
I haven't done much with it other than power it up and make sure it works (that took a while). My garage and my free time have been consumed by...
The first thing you have to decide on is how fine the detail needs to be in your prints. With a 50" 4K screen, you have 88 DPI, which gets you X/Y...
I'll definitely be following along. Like snokid said, shorter would be better to keep your attention. I'm looking forward to trying Fusion360....
This one should be good :)
