Separate names with a comma.
Some features disabled for guests. Register Today.
dddman, it's a little twitchy when you start changing the yellow boxes. I found that if I input the bit info and max spindle speed and then give...
Josh B submitted a new resource: Feeds and speeds calculator - an online resource - Free online feed and speed calculator While searching for...
While searching for some carbide bits for milling aluminum, I ran across this online feeds and speeds calculator. This calculator was found at...
Mark, Thank you Sir.
Thanks Thurmond. Have you milled any of this? I did a Google search on milling/cutting paper phenolic and came up with very little. Mark Carew,...
So, there I am starting a new project, the demolition and rebuild of a National Guard Readiness Center. Meanwhile, on my own time, I'm looking...
I use that spindle on my OX, works great and is super quiet. The only negative,, and depending on what your cutting, you'll be limited on your...
Thanks Mark Carew. If I had just a tad bit more patience, i think I could have fit a couple more pieces on that 12"x 24" sheet. I do need to...
After many hours of tweaking:confused:, head scratching (banging):banghead:, and a few cold beverages:cool:, my OX-alike is cutting like butta!...
I started $100 & $101 at 26.67 per which was found using the RepRap calculator found in the OB resources. From there I measured the exact distance...
current GRBL settings (giving best motion I can get so far) $0 10 (step pulse, usec) $1 25 (step idle delay, msec) $2 0 (step port invert...
So I reinstalled GRBL, re-flashed XPro firmware, reset all settings and created a new cut file. No glory, low speeds are definitely not something...
I'm running the same setup, I would recommend you go with a higher current output PSU. Although, the Xpro will only do 2.5A regardless of the PSU....
Hey Strooom, sorry to break in on your conversation. I see your using an XPro controller, are you by chance running Nema 23's? If so, what is the...
I'll check it out tonight, I'm just going to start over on the software/firmware side. I'll post my results.
And the plot thickens! Created a cut file in CamBam at a 1000mm/min speed and my machine started cutting (in the air) at like 50 times smaller in...
Nope, found a way around having to reinstall anything. First thing I did was check my settings and everything looked unchanged. No luck on my end,...
I did have it running decently, ran a few jobs cutting wing ribs out of 1/8" balsa...I don't recall the low speed chatter on those jobs. It seems...
Once, on the "Y" axis during my initial setup. Backed the pots down to around 75% for all axes and installed heat sinks. Haven't really ran it...
Irritating! Yeah, my steppers 23's are rated 2.8A...gotta say I'm kinda pissed off about this. Although, it seems that there are a lot of folks...
