Separate names with a comma.
Some features disabled for guests. Register Today.
What? Can you direct me to a link to that discussion. I wasn't advised, per se, but it seemed widely accepted as a suitable controller for an OX...
I'm running 24V 20A, wonder if I should get a PSU with higher amperage? Wish I could run at 300mm/min, but I don't have the RPM's in my spindle to...
Thanks for the input men, grilling and drinking beer. CNC will have to wait till tomorrow, have a good Memorial Day!
Just ran the same test at F2000, smooth! I adjusted the current to each stepper, to lock out, then backed each off until they run continuously...
Got the "jitter while stationary" stepper resolved, rerouted my spindle power supply to the other side of the gantry. I think the step jitter is...
Got some low speed stepper jitters. Due to my maximum rpm of 12000, I can only cut 1/16" ply at around 75mm/min using a 1/16" bit. It's like the...
Thanks Krishnakumar, what rpm are you running your spindle while cutting 50mm/min? I kinda feel limited with this spindle at a 12000 rpm max.
Anyone using one of the 400W- 48v-12,000rpm spindle from China fleabay, to cut balsa and light ply airplane parts? If so, could you share your...
Chris - Yes sir, I got them and in record time! That was some seriously fast shipping, thanks a lot and they look awesome. BTW, my wife had the...
Hey folks, I've been a lurking newbie for a while now and I figured I better make myself known. I'll start by saying that my wife is not happy...
Awesome, checked the actual distance traveled by all three axes and there true up to 250 mm. I stopped checking at 250 mm because that's all the...
@Macchp - thanks for the recommendation on the F200 command! After this command was accepted by UGS, I spent an hour just jogging my OX around, in...
Okay, that's what I figured but it never hurts to ask. Is it odd that the Z axis will respond but the X and Y will not? Doesn't the Fxxx...
Thanks guys. I tried the UGS as well and had no luck there either. I can get proper movement out of the Z axis, but not X,Y. Macchp, my set up is...
Trying to get at least a small bit of movement, but I can't get past the error - undefined feed rate. Tried the G01 F200 command with no glory....
So frustrated! Finally got my Ox built and now I can't get the controller to work...uggghhh. I built the standard Ox with all the components from...
Thanks Tweakie, 24v PSU is on the way.
Hey guys, Anyone power there entire machine (spindle, steppers, driver, etc.) with one 48v power supply? Or is it better to keep them separated?...
