Separate names with a comma.
Some features disabled for guests. Register Today.
I saw that in the new guide. I was holding off on doing anything in regards to leveling until I get the heater mounted since I will have to take...
Heated bed should be here tomorrow. Once I get that mounted and wired, it will be time to calibrate and level the beast.
A little wiring cleanup. I made a shroud for the molex connector on the carriage to provide some strain release and hid the wires... [ATTACH]
you may need to adjust the 0.51 and -0.51 to fit your parts.
I had this issue too when I printed them. Tried the scaling, but that also increases the cutout that holds the nylon rod and had the same wobble....
Keith made some recent changes to the Z axis parts that I want to use on here. I am having to modify them and when that's done, will try to get...
It's ALIVE!!!! [MEDIA]
Other than the heated bed, I believe it is all wired up and ready to go. I still need to calibrate it, but running a dry print to shake things...
Yes. It is 5 pieces that are bolted together.
If you want to discuss this more, it might be better to take it over to my build so as not to clutter up Keith's.
Here is the carriage I am using. It is very simple. It has two parts, the carriage and a belt clamp. The clamp is held in position with square...
Updates: Been working on the control box for the printer. I am using a Duet 0.8.5 for the controller and a 120v bed heater. Because of this, I...
I have done all my design in OpenSCAD. Fusion is on my list to learn when time permits. I used 20x40 because I was reusing parts from another...
I am working on a 300x300x300 version. I started a build here (eTrue Glide) to document it. I am using the Titan Extruder.
There is a difference in the tube between the lite and regular V6. The lite is make for lower temperatures because the tube goes further. The...
I was meaning the physical location of the wire routing. How the wires from the Z and X axis motor are routed around the extrusions. I think I...
Keith, do you have any pictures showing the routing of the wires?
I switched to some heavier springs and still have some play. Will probably end up using the double nuts.
Keith, have you seen any problems with the heated bed shifting because of fast Y axis movement? I can see some shifting if I push on the plate...
I use a 600W mains power heater. The old printer had a 300x200 bed and could get up to 100c in under 5 minutes. I just like the tooling plate...
