Separate names with a comma.
Some features disabled for guests. Register Today.
Question for those of you with the 3 screw setup. Do you find having the one screw up front in the middle getting in the way of accessing the...
Worked great when I got the hot end settings tuned in for NinjaFlex.
The Titan has a 3:1 gearing system built-in. This is why you can get away with the smaller pancake motor. I have two Titans with these motors...
Sounds like the belts are stretching. Does this happen every time after you tighten the belts?
Are they slipping out of the clamps?
I am using an AC powered heated bed so I don't need as much current over all. I am using a 12V 8A power supply on my system...
I like the E3D V6 hot end and Titan Extruder. I am planning on switching over to a nimble extruder when they are available.
Here are a couple pictures of the idler wheel. If I remember right, it goes bolt, fender washer, nut (on inside of vertices to hold bolt/washer...
And the homing speed is what I am wanting to change. Just don't want to go so fast it causes problems with the belts or hits the end stop too fast.
Question for those using two or more lead screws with a belt. What speeds are you running your Z axis at? I have mine at a pretty low speed...
I went with 300 because it worked out nicely when using 1m V-Slot. I cut exactly 300mm off 3 pieces and then trim the remaining 700mm to the same...
I also have 288mm log magnetic rods (wonder if we got them at the same place ;) My horizontals are 300mm and I have a workable 240mm diameter...
2x2x2 is doable, but you probably should look at the Triple C-Bot or the D-bot since they are designed for the larger bed sizes.
I think this is a bug in the system. I will stop getting notifications even though I check the forum after every notification I do get.
The replacement components need to be rated *OVER* 24v, not at 24v. 30v or more would be good.
I hope you weren't planning on running the Ramps board at 24v unless you modify it to handle it.
Use a 8mm approach inductive sensor instead of the common 4mm.
Looks good, but you probably should be using PET-G or ABS to print the structural parts like this.
You might want to print these one at a time in case there is a problem. Nothing worse than getting to the end of a long job like that to have one...
The horizontals are 300mm and are cut from 1m 20x40 VRails. After all 3 (6 with the horizontals for the top) were cut, the remaining part of...
