Separate names with a comma.
Some features disabled for guests. Register Today.
I have seen people report that Print Bite works with nylon. I use it on my printer with pretty good success with PLA and PET-G. Never tried nylon....
Heated bed with blue painter tape? You might need a better printing surface for nylon.
I thought nylon had to be printed on a heated bed otherwise it will warp.
Do not move it to github. Github is not a forum site but a source code revision site. We could have the files saved in github, but discussion...
I'll have to go back and look at those files later. Those weren't the ones available when I started mine. If they are done in OpenSCAD like the...
You will have to remake the carriage to accommodate the larger wheels. Is this the carriage that was included with the Delta6 files? It doesn't...
I'm not sure but I think that carriage design is for a 2020, not a 2040. Or you didn't get the mini wheels.
With the Duet, there is no need for Octoprint. I use it on my Printrbot, but the Duet's Web controller does the same.
I haven't. Moving to 32bit is more for supply compute power for other things, like a web server. Given most 8bit controllers run at 16MHz and can...
If you are referring to the web interface, this is something that the Dc42 fork of the RepRap firmware supplies. I don't think it is compatible...
Basically just connect the grounds together and apply the external to where it is needed. For example, the LCD display. You might need to cut the...
External 5v power supply to augment the ramps. Also look into the Duet board. I switched to that from the smoothieboard/smoothieware (the lack of...
I don't think the "bump-bump-bump" across an idler pulley is going to cause any problems. The teeth are close enough together that the belt never...
Wheel Tightener by ElmoC
I can put it up on Thingiverse if you feel it would be useful to the C-Bot collection.
Yeah. Used OpenSCAD. Here is the file.
Wheel tightening? Here is what I used... [IMG] [IMG] They are designed to fit around the wheel and put the pressure on the spacer, not the...
Got the coaxial adapter put on the shroud and it's working. I can definitely feel air coming out now. Still not as strong as I was hoping for,...
Sounds like I am using the same type of end stop as your are it sounds like. Since you are only using the ground and signal line, the voltage the...
While my C-Bot has been down waiting for a new bed heater, I have had too much time to think about things to do to it. One thing that has...
