Separate names with a comma.
Some features disabled for guests. Register Today.
Hi Glen, Attach your file if you can so we can try it. Cheers Gary
ER11 has good range for an openbuilds machine, google er11 collet set typical is 1-7mm Air cooled even heavier and bigger, I'm sure you can get...
Look for a 65mm spindle, can be longer and Er11 but ~half the weight. [ATTACH]
I would drill the small holes out for eccentrics, then it's all eccentric and more adjustable for square and everything. "If you cant make it...
Hi Andrey, Are you sure the noise is coming from the screw? The Delrin nuts are quiet, I've used a shot of Teflon dry lube on mine. but also ran...
Hi MTMMan, it won't "short out" but it won't deliver the full performance those motors are capable of, for the standard nema23 motors the xPro...
I'm using a nema4 electrical box made of steel, but before I "acquired" that I was going to use an old gutted pc case, without the pc in it....
I agree with Rob, run the Neg from the arduino to the negative signals (pul and dir) instead of using the power neg on the drivers. cheers Gary
Yes that's an easy fix, drawing the holding tabs. Cheers Gary
Oh Bats forgot to say.. regarding the A-B-C axis, Makes sense, I worked with commercial 6 DOF flight simulators and those would have been...
After re-watching Christian's videos, it looks like sometimes there is the lift after each 3D pass and sometimes there is not. Wonder if it comes...
yes, in the time it took you to write all that I could have fixed it for you.. maybe even twice ;) you are too much! lol
Good to hear you got it sorted, I think those will last a while like that, always good to have some spares just in case. Cheers Gary
Washer spacer in-between the bearings? if so make sure the bearings are fully seated, sometimes you need to press them firmly between two flat...
Tilt the gantry at the plates (if A-B is what i think it is), Or there should be enough play in the cast angles to move it where you need (using...
I'm sending the creator of Estlcam an email, hopefully he will help us. meanwhile it might be worth re-watching these two videos. [MEDIA] [MEDIA]
I don't think that will work, the Xpro is practically an arduino with GRBL pre-compiled on it. Use the arduino to drive some cheap steeper...
It uses a standard printer type usb cord, and usb 2.0 would be plenty. Cheers Gary
Normally Open is still NO, but when the arduino commands (NO to closed) it takes signal to ground (Like NPN transistor).. that's how all the...
