Separate names with a comma.
Some features disabled for guests. Register Today.
If you're making a hole the exact size as your bit you wanna use the Drill wizard, which is left of the 2D operations. If you're making a 10mm...
Its simply the clearance height. Retract height is when it does pecking or starts to plunge/helix, and clearance is for rapids.
use the Ultimate GCode sender, platform version. You can simply remove the jog commands. There is an assistance add on where you can pre-load...
Is there a trim pot? Try jogging it with the pulley slacked off.
Sorry for ignorance, but what are those electrical quick connects you are using?
You can cut much faster then that! Spindle speed should always be as low as possible, only up it if during a job it's being bogged down and needs...
Well, Chris and I went through the math of these motors, and 5k IS the max they can do (based on their RPMs and the steps needed to turn the...
14 hours in with assembly, loose ends, wiring, testing, etc etc. Ballscrews are a new challenge on a hobby level. My screw holes were slightly...
Before you start cutting too much I recommend you swap the Z nut out with an anti backlash one, and run dual belts. ( have a spool here if youd...
think the alu rails will be ok with the steel wheels?
I swore I did, but I apparently didnt. It was the other build where I linked it. just ask Mori for his email so you can talk outside of ebay....
^As for the wheel supplier, he seems to have closed his ebay page. I probably got his last few baggies. Opencreations in Europe seems to have...
I have the zip that I sent to Sean, but I'm not publishing these publicly with my logo in it and I want to make sure everything works first. I...
As in the model, 1 2080 for the Y's, and 3x 2080 for my X. Overkill? Maybe. Better safe then sorry and its only a few dollars difference to go wider.
Since it wont embed properly in the article [MEDIA]
In case its not obvious, I can jog, open files, and change the steps (10,1,0.1, and /10) all from the controller. I also can home, set machine 0...
Got it hooked up to KeySticks today [MEDIA]
I get them from this guy, this is the bit I was cutting with. 1/8" Carbide Endmill 4 Flute Flat Bottom Regular My Z is too sloppy for longer...
