Separate names with a comma.
Some features disabled for guests. Register Today.
Nope. Already at the lowest point. The upper mount is in the middle.
Finally swapped out the bed. [ATTACH] I goofed and kicked the endstop while walking on the bed when I was tightening the M5 screws at the rear...
Inductive Sensors in action. [MEDIA] [MEDIA]
Started work on the new wasteboard and the Tool Offset Probe. The bottom of the probe was milled out with the 'Hog' and as a test I cut the top...
@Mark Carew The original prototype was made with the Hog. Then I had a friend with a couple HAAS make the three in the picture. @EvanBruner It...
I didn't have too. My BoB supports 24V inputs.
[ATTACH] Next step is the wasteboard and the tool offset probe. (The probe has been milled out. Just need to sort out the electronics and the...
[ATTACH] [ATTACH] Endstops installed & the tool offset probe.
[ATTACH] Finally got the ER20 adapter / Air Diverter squared away.
C-Beam Rigid - 'The Hog' - Line 9
And for fun... [MEDIA]
[MEDIA]
There is lighting under the X Axis. [IMG]
[ATTACH] [ATTACH] [ATTACH] More pictures.
[ATTACH] 2 hr shake down / first ops. 25 sheets of lexan.
[ATTACH] [ATTACH] Mocking up the rotary and another glamour shot.
[ATTACH] To make it fair, I had Kyoujin make a part for the Hog :p
I think so. I didn't have to shim it for the DW611.
[ATTACH] I get about 6" clearance when the Z is homed. But this is mostly due to height of the Y/X endplates.
