Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks for the warning. I gathered from your initial post you were not satisfied with their shipping. Will have to find another source. As for...
Where did you get the shims and GT2-40T? From the original message, it sounds like you got it from robotdiggs. I was able to find the pulley...
One other question. What was the bearing this part was designed to use?
Looking at the STL I can see the lip now. Thanks. I think once I wake up more I might play around with it some.
Do you have the files as STLs? Never worked with 123.
When you say "motors" here, are you referring to the lead screws? Not sure I am following what it is you are suggestion. Do you have STL files...
That's what I was trying to find. This thread has just gotten so large it is getting hard to find things.
After getting tired of dealing with the two Z axis motors getting out of sync, I am looking at switching over to the single motor/belt...
What about grouping the individual files into subdirectories? You can just zip up the whole directory tree to distribute.
I originally had the middle one on my Printrbot. Switched to the spider type and glad I did. Saved my bed from some bad head crashes. I put...
I started with a default value and measured the amount of filament extruded vs the amount requested. So the calculation would be (REQ / ACT) *...
No one has had any experience with this? I tried another hotend with the same results. I'm thinking it could be the drive gear (MK8 I believe)....
I wouldn't expect a 2040 turned with the 20 side to the middle would have any more strength in regard to torquing of the frame. It would support...
I have seen a lot of designs that use 2020 extrusions which has a 20mm facing the center. Is there something specific you are looking for/at that...
I have been trying to finish up my C-Bot direct drive and running into an issue with it skipping. Seems if I try running it at anything over...
Gawd. No wonder my extruder was shredding the filament. It was set at 420! That was the default in the sample configuration file. I knew it...
I was just looking for numbers to get in the ball park to start the tuning. I know the steps for E is WAY too high right now. I am using a .4mm...
Trying to put some finishing touches on my printer and wanted to get some input on speeds. What are some good values for print speed,...
I designed a mount for a dial guage for the direct drive carriage that I am planning on using at first. Since I have a way to level the bed, the...
It came standard on my Printrbot Simple Metal and I really like it. I was planning on using an optical device on the C-bot. Haven't decided on...
