Separate names with a comma.
Some features disabled for guests. Register Today.
Wanted to share my new Duet case for my C-Bot... [IMG] Now I just need to get it all wired back up. :)
I had squeaking with my screws too. A drop of light mineral oil killed that mouse and haven't had a squeak since. Also using the delrin block.
When calculating for the size, plan for a 300mm x 300mm work area, but design for around 310 x 310. One thing I found when looking for build...
The heated bed is supplied from a separate power supply. The supply for the stepper motors has plenty of excess power available.
I have been using the timer, but can never get the smooth look that the layer trigger gives. Might have to turn off the Z lift on time-lapse...
Are you doing any Z lifts on moves? It has been awhile since I have tried time lapse based on Z height change and it seems like when I did, it...
Well. Did an experiment with that overhang issue. Modified a gcode file to remove the heated bed setting. Here are before and after pictures......
What timelapse settings are you using?
I'm really interested in what you come up with to resolve this as it is a problem I have been dealing with on another printer for some time. Might...
Those are a lot cheaper than the drop in T-Nuts. Might add some to my next MrMetric order.
It is a dial indicator (http://www.amazon.com/gp/product/B000NPPBVK?psc=1&redirect=true&ref_=oh_aui_detailpage_o08_s00) I use for leveling the...
My condolences. ;) What is it you are looking to get printed? I might have some time I could do some for you. p.s. I lived in Provo/Orem for...
Looks like it will work, but seems to be a bit of over kill. These are the connectors that I use... Male connector:...
The boards are roughly 40mm x 16mm. All the endstops of this style are pretty much the same for mounting holes and parts placements. As far as I...
Where are you located?
Info on available controller boards: List of electronics - RepRapWiki The link also lists which firmware will work with each controller. Any...
32 bit minimum for the processor on the controller. While you can run a RAMPS at 24, it takes some work. I am going with a Duet v0.8.5 board...
I'm doing the same, only I put the thumb wheel in a slot so it is trapped. I like your setup and going to try it out tonight.
Did you use washers or shims? There is a difference.
Check out this link for how to do this.
