Separate names with a comma.
Some features disabled for guests. Register Today.
Do you have a work in progress Sketchup Component Library that you can post?
I do have a Prusa I3. I end up adjusting the Z every few months and I print 1-2 per week. I do wish the two Z motors were held in sync by a belt....
I still dont see why its not a good idea. so im still going with it until I can get more facts. before i switch to a single geared 17 or a nema 23...
well the belt will help keep them in sync. but really the reason to have too is to reduce load on each.. vs having 1 Nema 23. if one nema 17 skips...
Thoughts on this Z belt config red Nema 17s with 20 tooth Pulley Green Idlers Blue 40 Tooth Pulley on ACME screw I like having two 17s working...
I notice that both 1/4" and 6mm are available for eccentric. Not sure why tho. is there a specific reason both sides are available. why not just...
Thank you very much. thats very helpful
should be spot on within .1mm, keep refining your steps
everything was working well until i tried to rotate and then everything started to seperate and then i hit rebuild half of the components...
Thanks Joe. it took some messing with but I got it working!. your an amazing person! :)
Sounds good.. now how to I set that up lol
If I move the corner, i want it to adjust
Im new to Solidworks. still working through tutorials. I would like to be able to insert two corner components and then say fille the space...
Have a look here. hopefully you can just resave the file with references 2012 SOLIDWORKS Help - Save As with References
Your solidworks file has alot of references. would you be able to post the references too.
Thanks.. the more i mess with my build the more it looks like yours! lol. hope you dont mind
the pieces that you are using to mount the acme screws to the base. can you post a link to where you found these please.
Cold Saw if you got the coin :)
Cant wait to see how this ends up. I want to do the same thing
I created a rough rendering of a Sliding T Joint any reason this wouldnt work in reality? I would need to add a spacer to the TJoint Plate. so it...
