Separate names with a comma.
Some features disabled for guests. Register Today.
Can be tricky making sure everything is on one plane and not 3D.. I use draftsight and it's basicly Autocad 2D and works great for making DXF for...
Sorry Yes you are correct, I think i was looking at an old GRBL settings list, $5=1
This video should help, if you stick with the pnp you can invert the input function.. $6=1 (Edit!! should be $5=1 for home pins) in grbl...
Hi Seamus, do you have the spec sheet for the ones you have? thanks Gary
Should work great, would love to see it! Two issues Have you found a supplier with longer leads? all I can find are 2mm lead screws, this would...
This is from the xpro wiki guide... There are two motors sold on openbuilds, a standard nema23 and a high torque. You want to set the current...
Troy, great looking machine! I really like how simple and clean the design is, looks like it performs great! Cheers Gary
Ok Shane, the trim pots on the Xpro is where you need to adjust the current. When the current is set you will be surprised how strong these motors...
Yes the weird stutters noise is the motors stalling and loosing steps, did you try increasing your current?
Hi Shane, Belt slip? they should never jump over a tooth, did you get the pulley and the belt from the same supplier? Did you loctite the pulley...
Without dual belts it's easy, just fish the belt through.. with dual belt, not so much :) Cheers Gary
Always start your system (first start) with nothing connected and get everything sorted and moving correctly before connecting the couplers to the...
Oh ok, thought you were using ATX which in that case the solder jumper sets it to use the ATX standby feature. You should not need the jumper at...
E-stop should not lock the motors, is it just NO instead of NC? can you run with the e-stop pressed? did you follow this? [ATTACH] Cheers Gary
Hi MHSB, don't worry about the version, it's not the issue. Have you loaded the xpro drivers on your pc? found here I think arduino driver works...
show us your interface settings, thanks Gary
openbuids controller? xpro maybe? Most likely a loose or broken wire connection to that motor. cheers
Are you sure they are both going the correct direction? disconnect the screws and make sure they are both going in the same direction first. Also...
too deep of a cut maybe.. need more info
Yes that is reversed good find. might not have been what let the magic smoke out, but doesn't help either. Yes those drives will fully power the...
