Separate names with a comma.
Some features disabled for guests. Register Today.
Sounds fun. Would be interesting to see a diagram and the power numbers through the transmission system.
You asked about ball screws. Do you actually have ball screws, or do you have lead screws? If you have lead screws, then yes, on a light-duty...
Ball screws tend to take an ISO 68 type oil, relatively thick and sticky but still a long way from being a grease. It can be injected through the...
Certainly, but it would have to be performed by the host software, not grbl itself. G38.2 to probe, G38.3 to query probe result, repeat,...
Oh sure, what's then DONE with the probing routine is another matter. Fairly simple vector transforms, but certainly a good amount of it, plus, as...
Look at the explanations of grbl's settings on this page: gnea/grbl $110, $111, $112 control your maximum rates by axis. If left at defaults,...
All a G-code sender has to do to replicate the probing routine is do a whole bunch of G38.2s and between each one, query G38.3 and write it to a...
It seems somewhat usable as a logic-level FET, judging by the datasheet. I prefer the Vgs and Rgs (and Idmax and Qg and...) characteristics of the...
Me @ this thread: [IMG]
[ATTACH] :O Since when was that an option?! I tried it multiple times within the last few months, including this week! That's SUPER exciting....
$6 is Probe Pin Invert. Normally ($6=0) it's held high, and your probe switch needs to ground it to trigger. If your probe is connected to +5V,...
Being used to the high-speed, streamlined media handling capabilities of social media, would it be feasible to update the forum software's...
Apparently yes (at least, on Windows). [ATTACH] Oh, there it is: [ATTACH]
Well, not so much grbl-incompatible as CONTROL-incompatible. All of the advanced, non-motion control features are deliberately devolved to the...
That was my first thought as well, but I think # actually denotes variables. This is clearly intended more as a LinuxCNC thing, but with a...
You could try bCNC, I know that's written specifically to allow various types of probing, canned cycles, other more advanced stuff that grbl...
You can send direct individual G-code commands or specific realtime grbl commands (which include some G-code) for jog. $J is the realtime option:...
Looks to me in that picture of the bottom of the board like the bottom two pins are purely mechanical, just the little metal casing tabs to hold...
Pic of the buck module? In theory, if the pot runs on a 5V subcircuit, it would be pretty trivial to just remove the pot and send the pwm signal...
I actually see a few results (once I mentally filter out the Far Eastern supplier results) on Google for "DIY flatbed UV printer" or something...
