Separate names with a comma.
Some features disabled for guests. Register Today.
I'm looking for a 8x12 plate myself. Will have to email them and see if they can do a custom size. I would love to get one with the back cut...
Where did you order your MIC-6 from?
I like that design. I may just have to rebuild mine to handle a 12x12 bed and use this mod. Would only have to recut the 4 side bars.
Crappy color balance on the camera - those white squares are actually blue. :) But yes, they are the heat transfer pads. My PCB was actually...
My first print! Still need to do some adjusting though. 25mm test cube. Measured at 24.9 x 25.03 x 24.33 so not bad for a first shot. [IMG]...
Does anyone here use a Smoothieboard? If so, do you have a case for it? All the ones I have found on Thingiverse seem to be for the original...
So this is the procedure I use for adjusting the height of the nozzle to the bed on my Printrbot. I manually lower the hot end until it is about...
Okay. Got how the bed leveling work. Been thinking about installing a crossbar between the two arms so I could do the 3 screw setup. Shouldn't...
Well, I am nearing the end of my build. Just about have everything finished. Waiting for a new hotend to come in (hotend on my Printrbot went...
My oldtimers must be setting in. Where did you add it at? Couldn't find it in the file section.
Did I miss the stl post? Didn't notice anything in the file section.
Carl, how do you have those cooling fans mounted? And are those shrouds custom or ones you found?
It takes more current to run 24v across the 12v circuit than it does to run 24v across the 24v circuit. If the PSU was having problems providing...
Not sure exactly what you are trying to say. The board works out like this: Across the 24v pads, the resistance is 5.6 ohms. The board will use...
I measured while heating. I don't think it is the PSU as it was able to provide the much higher current required to do the 24v on the 12v...
Running 24 on the 12 does heat up faster as would be expected. There was minimal voltage loss and the PSU is 14.6A so has the power to run it, as...
All the resistance checked out properly. Ran the heater bed with an amp meter and it was getting the power that it needed. Switched it over to...
If you want to go 30x30, you might want to look at the Triple C-Bot by adamcooks (http://www.openbuilds.com/builds/triple-c-bot.1757/). He built...
I probably missed it, but couldn't find the link to those pads in your BOM.
Came up with this idea for running the cables to the heated bed. [IMG] [IMG] [IMG] Thinking of gluing up the bottom half to keep it...
