Separate names with a comma.
Some features disabled for guests. Register Today.
Was thinking if you were in Alaska or Hawaii it may have been more expensive priority. But it shouldn't be any greater cost to Florida. Give...
As I understand how stepper motors work, even when they are not moving, the full current the driver is set to is still being sent to the motor....
I would email or call them and ask why. Where are you located? That link did say most, but not all, went priority.
I have been printing mine at 250c, 0.2 layer, and 5 shells top, bottom, and sides at 50% infill for the structural parts, no cooling, 70c bed...
The problem with hooking them in parallel is they could draw too much current from the driver. The driver is rated at two amps and the motors I am...
For those of you doing the dual extruders, what electronics are you using and how do you have the two Z motors wired? From my research, you would...
Answering my own questions again. I found these springs......
This is what I got too and I *LOVE* printing with this stuff. No more expensive than PLA and gives better results for me. I just wish it came in...
One other question about your extruder. How does the pneumatic coupling attach? Is it just sitting loose on the top? There doesn't seem to be...
Carl, was building the extruders you link to and got them all build except for the spring. Where did you get the ones you used? Could you give...
How is that B'Struder working out for you? Looking over different ones trying to decide on a design.
Okay. Took it apart and noticed there was some extra material in the slots. Cleaned that out and was able to get them tight on the bar. Maybe...
I can take a picture, but don't think it will really show much. I was planning on switching to a Chimera later so will try printing the single...
It's not the hot end mounting that is loose. It is the carriage on the XY bar that is loose.
I just installed my hot end carriage (using the dual one) and there is some vertical play of about 1/16 - 1/8 of an inch. I can lift it up and...
I don't know if it has been brought up in the past, but I found these end caps for the V-Slot (http://www.thingiverse.com/thing:398515). It looks...
In answer to my own question... I was able to successfully connect the Acme Block to the Z-Bar using 30mm M5 screws. It was a bit tight but I...
Will try grabbing some M5 30mm from HomeDepot and give it a go. But now that your reminded me of that picture... I like the bracket he made for...
I just printed the AcmeBlockHolders and was test fitting it with the block. I measured the distance between the face of the block and the back of...
That was the one I had been looking at. Wasn't sure about the extra size if it would fit properly.
