Separate names with a comma.
Some features disabled for guests. Register Today.
For the 100%, you need to go back to stock driver and then re-patch when your initialized your new cartridge. Zero percent... maybe someday :)
Which tom??? :rolleyes: <<<=== not the FW guy.
The patch is of no concern, of course. There is a sensor in the print-head that is seriously sensitive to any sudden change in feedback. I...
Enjoy :)
Very unusual. Glad all is good.
Those bins are in there very tight. If yours is no longer tight, it may have broken the catch. Otherwise, it may be that you are not providing...
Find yourself some nice flexible 16-awg wire (high strand count silicon test leads) for the heater pad.
While we're looking at the internals... Anyone figure out the parameters that triggers this notice? Some units are extremely sensitive while...
That's kind of what I was getting at. The App is 3D Builder by Microsoft and according to other posts, Microsoft will load the driver if you plug...
Would it help to have Microsoft download the driver for 3D Builder with the cube plugged into it's USB-B port? At least you have an interface...
Stepper motors are noisy in any application, but add all that resonant plastic parts and loose screws into those plastic parts and you get...
We are also working on a better feeder system. I highly suspect that pre-loading is causing the issue with poor "dot" performance. A couple of...
You could run several heaters off that :)
[ATTACH]
If you have used this printer for a while, you will probably already have collected several cartridges. If you were fortunate enough to save a...
Do you have some junk computers around? You might look at the 12V spec for the internal power supplies. Many have a lot of 5V current and often...
Nice find, Kiza. The magnets is the problem. If you epoxy your magnets (or similar magnets) to the silkscreen side of the pad where the original...
Which firmware version is giving you trouble?
Interesting and makes perfect sense. J.B. In the literature, it only refers to this port as "future expansion". They must have meant 3rd party...
Jacksonianbriggs, how did you make that work? I've been looking at this also and it just started looking more and more complicated to get the...
