Separate names with a comma.
Some features disabled for guests. Register Today.
Double check its still working in CONTROL, as that sounds almost like $4 Invert Enable is set incorrectly - should be $4=0 To move motors you...
Yes, Tool On looks at the Grbl Settings Do a EEPROM reset [ATTACH] Then try again Import the backup from the Restore Backup button [ATTACH]...
But Where do you get the error? Tool On Menu? From a Job? Etc (see my earlier reply) Yes you should: [ATTACH]
Thank you. We note you already have an open ticket with the store about this. Please continue with the store to ensure we provide you with the...
Or while doing the first Z+ moves, perhaps hitting the Z axis hard stop and losing position? (Heights set too high?)
@Terry Smith from Mac Compatability @Elliott simmons (from) X32 Drivers @Dov Rosenberg from Trying to connect to Blackbox x32 with Macbook issues...
Duplicate of support ticket 66345 - please check your email for reply from the store. Please avoid cross posting to multiple support channels (:...
The Tool On menu looks at $30=1000 (usually for a plasma) to scale the M3S value for the menu. If your $30 is not set to a number then NaN is "not...
Change to what you need and save the Post
Post processor for which of the many CAMs? (:
Check grubscrews on shaft couplers, sounds like slight slipping on leadscrews. Make sure you have a grubscrew on the Flat of the motor shaft, and...
With that kind of stuff we mainly prefer to stay hands off, but https://docs.arduino.cc/retired/hacking/software/DFUProgramming8U2/ perhaps...
Unplug Y motors (wiring) Spin leadscrews by hand until somewhat square Replug wires Jog into the ends to square relative to base (Check base is...
Not supported at this time sorry
There is no difference between Linux/Windows in our code. Is it a genuine Arduino, or some far east fake that cheaped out and used a CH340 USB chip?
AC EARTH to DC GND short somewhere in your system (these would normally be seperate, somewhere you have a leak enough to get current to flow so...
No drivers installed, or that would have been SLAB_UART Checkout the BlackBox Documentation, section 4 (and the rest of the docs too, also full...
Anything else attached to laptop? Laptop run off batteries ok just issue when its PSU is plugged in? PSU a 2-pin plug? Try reversing it -...
Then you really should checkout the RoutER11 CNC Kit Re-engineered with upgraded bearings, 'closed loop' speed control, ER11 collets etc. Its not...
Grab a RoutER11 CNC Kit Mounted into our Router Mounts using Router Mount Adapter
