Separate names with a comma.
Some features disabled for guests. Register Today.
If Vectric gets too tricky for you, can also look into DeskProto offers CNC machining for non-machinists - their rotary is a little easier to...
Whipped up a couple simple feet that can clip into the bottom your Interface for those of us that like using our Interface on the table, but just...
Do the tests... Unplug them one at a time. Particularly if you have any limits mounted "upside down" or without rubber spacer. If its not there...
Reread above then. The VFD "must" be Earthed. Thats the symptom The SHORT is elsewhere - something else connecting DC GND (used by low voltage...
That part is fine... Spindle should be EARTHED. But Earth and DC GND should NOT be connected and somewhere in your system it is. See above
You should be on V1.42 OpenBuilds-Fusion360-Postprocessor/OpenbuildsFusion360PostGrbl.cps at master ·...
Please keep the Meanwell, its appropriately spec'ed for the controller with plenty of headroom. A "bargain" 600w sounds like a cheap LED PSU with...
@terjeio please see above
The regular NEMA23s would be fine: NEMA 23 Stepper Motor
The theory is simple. Steps per mm (as its old grbl, unit ignored steps per mm works as steps per deg) set to 444 should give you matching...
Pushed a fix: Fixed misc bugs from new UI work / variable spindle / etc last week · OpenBuilds/OpenBuilds-CAM@d42b547 Only adds the spindle rpm...
[ATTACH] Compressed the elements a little to account for the small screen resolution. Ctrl+F5 to refresh the page and it should fit a little...
4T is usually for foot pedals. Tap switch to start arc. Tap again to turn it off. 2T is the right one (on while contact is switched, off when...
Never been tested so cannot confirm.
Short via spindle body > spindle earth > mains earth > accidental short to DC GND somewhere? Process of elimination, unplug PC (some older...
Your screen resolution a bit low - guessing 1366x768, might have to drag toolpath and documents sections smaller (vertically ) to show all 4 steps
Always read the Changelog OpenBuilds-CONTROL/CHANGELOG.txt at 24cedb48bc77c6a25e6452e479fa1c8469318be7 · OpenBuilds/OpenBuilds-CONTROL
Will add some improvements as time goes on good suggestions thanks
Did you enter a value for Spindle RPM?[ATTACH]
As the sizes differ its probably two similarly named files but not the same file. Use 8.3 format file naming - Interface doesn't currently...
