Separate names with a comma.
Some features disabled for guests. Register Today.
Boxes usually doesn't help much (cables do most of the radiating)
Yes, EMI from the VFD. Rewire VFD properly (earthed VFD and spindle body, and spindle cable properly shielded)
Just make sure your controllers input for the probe signal matches. Putting 24v power on probe but wiring it to a 3.3v controller would be bad (:...
3.3v to 24v yes. LEDs will just be brighter on 24v
Post a Grbl Settings backup for review. And are you measuring same with VFD disconnected as well?
Its built in in the Wizard. Macros are up to you
Ahh sorry, this thread is more about torsions for under the LEAD1515 (and LEAD1010)
[IMG] Only thing that caught my eye is the machine isn't going to be applying force as shown. Its two beams front and back and couple runners...
Loosen all eccentrics fully. Loosen the wheels on the fixed side - the holes has a little play in them - press the wheel inwards before...
Check the link - extensive discussion on calculation as well as tutorial how to wrap in there.
We run dual-Y motors each on its own driver typically: See docs:blackbox-x32:connect-nema23 [OpenBuilds Documentation]
1) Apply some Dry/PTFE lubcricant 2) spin it in and out of the nutblock with a cordless drill a couple times to help the nut bed in. Unless the...
I assume you don't have a Y axis (which would be present in default sequences) - so its waiting on the Y switch (Normally XY homes together - so...
Relay 1 is already a Tool Enable so even better. You can use Relay2 with Relay1 to act as Enable and Direction change if you want to as well (as...
The old discussion did predate the newer X32, so you should be able to use Relay 1 as an Enable on newer X32 purchases (recent)
Are you sure your BlackBox is that old? We stopped including it as its been a couple years since the older versions were around. Either way wait...
Thats the Ping Pong management described in the wiki. Grbl v1.1 Interface Still needed to avoid overrunning the onboard buffer that often looks...
Yes, but make sure you either also set work coordinates (if your moves are in work coordinates) or otherwise always move in machine coordinates.
Is that complete? Or its just not enough, I don't see queue management like char counting buffers etc Reread Grbl v1.1 Interface Maybe checkout...
Good luck, the V1.3s arent likely to be affected by drivers as much - the old FTDIs were solid chips. Double check all wiring for shorts etc too...
