Separate names with a comma.
Some features disabled for guests. Register Today.
Yes, I don’t know if anybody has dual belted GT2.
Yes, like $18 for a real one on amazon, I know some use an Arduino Nano and the a screw shield for that.. Arduino Uno most common.
Hi Ashish, Just get an Arduino and screw shield (makes wiring easy) and the four discrete drivers, who makes the DB542t? For software Estlcam...
Just watched your electronics setup, great job on the video.. Couple tips; Micro-steps - don't use the max, you only want to use the most that you...
Hi Spider, Dual belts helps reduce (almost eliminate) belt stretch and tension issues. Eccentrics should stay the same when belting is done...
Great job on the video's, those spindle mounting blocks are very nice! subscribed
Draftsight is just like Autocad, even the keyboard commands are the same, plenty of YouTube tutorials, it's simple 2D drawing. Cheers Gary
Estlcam is great, if you want precise make DXF files on a cad program, a good free one is Draftsight :)
Ok, so it's only happening on one of the Y sides, take that belt off, maybe it is damaged.
Hi Spider, It sounds like something I've seen before where someone had belts from one supplier and pulleys from another and they didn't quite mesh...
so with the system on, you should be able to work zero xyz at the start position and jog anywhere you want and then hit start and it will move...
A motor and a generator are the same, when you spin the motor (manually) you are producing voltage. The voltage is proportional to the speed you...
don't do that, the motor is generating when you spin it and you are hearing that.. if it's connected to the driver then you can damage the driver....
simplest way to zero Z is to use the Jog to get it to the surface, and use a sheet of paper, slowly lower the z when you can just feel the paper...
Yep, like Peter said... when you re-flashed GRBL the default was loaded again. That new board you are looking at, is another all in one board,...
i doubt the movement caused the board to fry.. the current is limited and the board is protected. Post your grbl settings for your xpro here....
And just as important as the motors is the proper drivers for the motors, that can deliver the current needed.
1) Nothing wrong with using an arduino for control, you will then be using GRBL or Estlcam.. With GRBL you can use Universal Gcode Sender (UGS)...
Coneheads are very strong...
Yes, if you snapped a belt it was too tight! have you had the issue since double belting? with double (dual) belting the only tension is the...
