Welcome to Our Community

Some features disabled for guests. Register Today.

DIY LED acrylic lamp

Discussion in 'Laser Cutters' started by quyngan, Apr 4, 2017.

  1. quyngan

    quyngan New
    Builder

    Joined:
    Apr 4, 2017
    Messages:
    2
    Likes Received:
    2
    quyngan published a new build:

    Read more about this build...
     
  2. Giarc

    Giarc OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jan 24, 2015
    Messages:
    3,022
    Likes Received:
    1,690
    I would love to know what bit, spindle rpms, and feed rate you used for cutting the acrylic.
     
  3. quyngan

    quyngan New
    Builder

    Joined:
    Apr 4, 2017
    Messages:
    2
    Likes Received:
    2
    I've changed a little bit. the acrylic is tough for cnc spindle but it could be easily cut by laser.
    I've use 300mm/min feed rate and 4000rpms spindle. But the quality of the edges of the acrylic after cut is totally disaster.
     
  4. Kevon Ritter

    Kevon Ritter Veteran
    Builder

    Joined:
    Apr 30, 2015
    Messages:
    597
    Likes Received:
    294
    Cutting acrylic on a CNC is a piece of cake. When dealing with plastics, heat is your enemy. To help with that, you want to remove chips. An o-flute is the only endmill I use in plastics of any kind (except HDPE). I have a router. I believe I had it set to 20k rpm, 1000mm/min feed, 300mm/min plunge, and a 2mm max DOC. Holding the work piece starts to become a struggle after this point for me.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice