Welcome to Our Community

Some features disabled for guests. Register Today.

EleksMaker® ManaSE 2 board, adding controls for GRBL

Discussion in 'Controller Boards' started by RegPye, Feb 21, 2018.

  1. RegPye

    RegPye New
    Builder

    Joined:
    Jul 1, 2014
    Messages:
    15
    Likes Received:
    7
    have a EleksMaker® ManaSE 2 controller board on a home built laser engraver.
    It is working fine, but I wanted to add a couple of extra controls for pause and resume, but the board doesn't have any connections for those.
    Can I add my own to the Arduino nano pins directly? I am running GRBL 1.1f for the firmware.

     
    #1 RegPye, Feb 21, 2018
    Last edited: Mar 1, 2018

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice