Welcome to Our Community

Some features disabled for guests. Register Today.

Fast way to start a repeating job ???

Discussion in 'Interfaces' started by Tomas Jelinek, Oct 1, 2024.

  1. Tomas Jelinek

    Builder

    Joined:
    Oct 1, 2024
    Messages:
    1
    Likes Received:
    0
    Hi, I am using blackbox X32 and I also bought an interface, but I still have a big problem.

    I am using my engraver for repeating work - hundreds of runs of the same job over and over again.

    Is there an easy way to start/stop job using some buttons ? Why do I have to load the job every time in interface ? Why isn't there just run button when I load it and it stays.. ? I don't care about fancy "job done" screen. I can see that on my machine :) I need to be able to run the job again and I need it fast.

    Can someone point me to how to do it with interface ? Right now, I have wireless mouse with tape over laser connected to the computer. I am pressing left button to start a job. But that blocks the computer.

    thank you
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice