Welcome to Our Community

Some features disabled for guests. Register Today.

GRBL controlled Laser does not turn off when traveling

Discussion in 'CAM' started by LR7, Apr 24, 2023.

  1. LR7

    LR7 New
    Builder

    Joined:
    Apr 24, 2023
    Messages:
    2
    Likes Received:
    0
    I installed a small laser to my 3d printer, which is being controlled via the fan control.

    I love your page/tool CAM and already got it to work better than with any software I tried before (LightBurn; Inkscape extensions, Creality Workshop,...)

    However, I cannot find an option to tell the laser to turn off when traveling (M106 S0 or really low). Not in the tool / documentation or any thread.

    Is there someone with experience who can tell me if it is possible, and if how I can set it up (without having to add it to the gcode in every travel line)?

    Thanks in advance and Best regards
    Linus
     
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    14,945
    Likes Received:
    4,297
    Its meant for use with Grbl v1.1 Laser Mode
    Ie. G0 = move, G1/2/3 = cut.

    You need a controller / firmware that complies
     
    LR7 likes this.
  3. LR7

    LR7 New
    Builder

    Joined:
    Apr 24, 2023
    Messages:
    2
    Likes Received:
    0
    Thanks for the quick reply.

    So no known quick&dirty work around?
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice