Welcome to Our Community

Some features disabled for guests. Register Today.

I'm easily confused

Discussion in 'CNC Mills/Routers' started by GrayUK, Jul 10, 2014.

  1. GrayUK

    GrayUK Openbuilds Team Elder
    Staff Member Moderator Builder

    Joined:
    May 5, 2014
    Messages:
    1,668
    Likes Received:
    627
    Hi Mark.
    Thanks for letting me know my order so far, is on its way. :thumbsup:

    Right then. Can you put me right with regard to the shims and the spacers? :confused:

    I held off ordering them before, because I knew there were going to be changes, but I see there are some in stock now.
    So, are these the new ones, and which shims/spacers, and how many do I need now, if they are thicker or thinner?
    I also note that the Gantry plates advertised in the shop, are different than the original shape. Are these the new ones also? Can you suggest, and name, what is in a complete set of plates for my future Ox. I need to pre-order!
    Can I not "pre-order" a couple of spacer blocks and wait for them to be in stock as well? :)

    Cheers
    Gray
     
  2. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,760
    Likes Received:
    2,443
    Hello Gray,
    I am thinking that this conversation is supposed to be part of a PM? I am not following the start of this.
    If you could please send it in the PM so that i can follow as I am easily confused as well ;)
    Thanks
    Mark
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice