Welcome to Our Community

Some features disabled for guests. Register Today.

INTERFACE CNC Touch Controller

Discussion in 'Interfaces' started by gsw, Jan 25, 2021.

  1. gsw

    gsw New
    Builder

    Joined:
    May 1, 2018
    Messages:
    6
    Likes Received:
    7
    I got my new interface up and going, but am i going to need to load my code every time i use it! on my computer all i need to do is hit run each time, any views on this
     
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    15,010
    Likes Received:
    4,304
    Not sure I understand? The point is that the Interface replaces the PC? I.e for folks who want to run the jobs directly on the machine, because the PC is in another room, they want to keep it away from the dust, etc

    See docs:interface:usage-instructions [OpenBuilds Documentation]
     
  3. gsw

    gsw New
    Builder

    Joined:
    May 1, 2018
    Messages:
    6
    Likes Received:
    7
    ok when i start the interface i go and get the file where it says load file from usb flash drive, then i run file. when the cycle gets done and i say ok then im ready to run it again i have to go get the same file from the usb flash drive to run it again. it looks like it should stay loaded until l am done with it. i run my project as a sealer so i run the same job over and over.
     
    #3 gsw, Jan 25, 2021
    Last edited: Jan 25, 2021
    sharmstr likes this.
  4. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    15,010
    Likes Received:
    4,304
    Ok thanks for the suggestion, will consider
     
  5. Peter Sesselmann

    Builder

    Joined:
    Oct 21, 2020
    Messages:
    21
    Likes Received:
    2
    I would like this too...
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice