Welcome to Our Community

Some features disabled for guests. Register Today.

micronox

Discussion in 'General Talk' started by sw3Dp, Apr 26, 2015.

  1. sw3Dp

    sw3Dp New
    Builder

    Joined:
    Apr 26, 2015
    Messages:
    29
    Likes Received:
    8
    Is this the place to ask novice questions?
     
    #1 sw3Dp, Apr 26, 2015
    Last edited: Apr 26, 2015
  2. Ronald van Arkel

    Staff Member Builder Resident Builder

    Joined:
    May 7, 2014
    Messages:
    472
    Likes Received:
    245
    Hello sw3Dp,

    Sure you can ask all you want, we´ll try to help you out. Just remember to study a bit before you ask. Later on we would appreciate if you share your knowledge with us as well.

    -Ronald
    OpenBuilds México
     
    GrayUK likes this.
  3. Rick 2.0

    Rick 2.0 OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Dec 20, 2013
    Messages:
    2,897
    Likes Received:
    1,555
    It's probably best to ask in the specific section of the forum related to the question, i.e. the Mills/Routers section, the 3D Printers section, the Controller Boards section, etc. You'll get better answers that way. A lot of people only review the sections they are interested in.
     
  4. sw3Dp

    sw3Dp New
    Builder

    Joined:
    Apr 26, 2015
    Messages:
    29
    Likes Received:
    8
    Thanks Ronald and Rick,

    I'm approaching the 72hr mark and just beginning to find the gems buried in the specific discussions. It's that feeling that after a full day at the pc with no answer found, that I won't find it without a trail guide, nice to finally find a RR crossing sign, believe me I don't know when to stop sharing.

    jack
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice