Welcome to Our Community

Some features disabled for guests. Register Today.

Noisy Y axis

Discussion in 'CNC Mills/Routers' started by Rendermandan, Feb 17, 2016.

  1. Rendermandan

    Rendermandan Well-Known
    Builder

    Joined:
    Dec 4, 2015
    Messages:
    107
    Likes Received:
    52
    I finally got my C-Beam machine up and running. After a short while during alignment/testing, I noticed a weird noise coming from my Y axis. The X and Z axis are smooth and "quite". The noise sounds like kind of like a squeak or binding maybe, hard to describe. So far, I have checked to make sure the base runs smooth on the rails. The lead screw is not to tight between the ends. The flexible coupler has space to move, and I have oiled the lead screw.

    Could it be the anti-backlash block? I'm not really sure how to adjust it properly. I screwed in the grub screw until it touched the block, then added the nut to hold it in place. There was no backlash in axis so I thought I had it right. Is it possible this has moved and causing the noise?

    Thanks!
     
  2. Hunter Dunbar

    Builder

    Joined:
    Jul 1, 2021
    Messages:
    3
    Likes Received:
    0
    I had the same issue.. did you find the problem?
     
  3. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    14,927
    Likes Received:
    4,291
    Squedking noise? Lubricate your leadscrews with NB Dry/ptfe lubricant. Do not use oil
     
  4. Derek Reich

    Builder

    Joined:
    Dec 28, 2023
    Messages:
    25
    Likes Received:
    1
    I also am experiencing some sqeaking/groaning kind of noise when the gantry is moving. I think it's coming from the X axis, but it could also be the Y. So I can just put some ptfe on the lead screw itself, or in the block that it screws through? I have some Boshield T8 here which is a dry lubricant, but it does not have ptfe, I think it's paraffin. Is there a brand you recommend?
     
  5. Giarc

    Giarc OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jan 24, 2015
    Messages:
    3,008
    Likes Received:
    1,676
    You do not want to use paraffin. I use Blaster Dry lube with teflon and it has worked well for me over the years.
    upload_2024-2-12_20-40-6.png
     
  6. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    14,927
    Likes Received:
    4,291
  7. Derek Reich

    Builder

    Joined:
    Dec 28, 2023
    Messages:
    25
    Likes Received:
    1
    Thank you both! Your assistance and prompt replies to this forum are invaluable. Especially for a neophyte like me.
     
    Peter Van Der Walt likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice