Hello Everyone, I'm Back!! I have learned a lot since my last post. Except how to set up touch off on my plasma table. I have searched (what i think) high and low but can't seem to find answers to the questions i have. I installed the limit switch on my floating head but that's as far as I've gotten. I'm not sure what/how/where to do the rest. Is it in fusion 360, OB Control, GRBL settings or the gods of plasma cutting. I'm sure I have settings to enter somewhere but don't know where or how. I'm sure I'm not asking the right questions when I search it. I'm using OB X32 motion controller. Please help this old guy out! TIA!!
Mostly CAM setups. Use our Fusion Post or OpenBuilds CAM Search Results for Query: Plasma. Ihs | OpenBuilds Did you watch Dr D Flos video? Bit outdated (CAM looks a bit different these days Openbuilds CAM: Initial Height Sensing setup help needed and I think the Fusion Post OpenBuilds-Fusion360-Postprocessor/README-plasma.md at master · OpenBuilds/OpenBuilds-Fusion360-Postprocessor only came out after the video) but its still valid to learn how it all works
