Welcome to Our Community

Some features disabled for guests. Register Today.

Vfd speed control through xpro v4

Discussion in 'General Electronics' started by Rob Atha, Apr 12, 2020.

  1. Rob Atha

    Rob Atha New
    Builder

    Joined:
    Aug 19, 2018
    Messages:
    53
    Likes Received:
    7
    Hi all

    I’m after abit of help, I’m setting up a 1.5kw air spindle with an XSY-AT1 VFD but I want to control the spindle speed through my X-pro V4.

    I’ve connected the v4 pins for common and spindle pwn to com and VL1 pin on my vfd but can’t get the spindle to spin up.

    can anyone offer assistance?
     

    Attached Files:

  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    15,010
    Likes Received:
    4,304
    not familiar with the particular VFD - XSY-AT1 VFD on/off and speed wiring enquiry
    but generic answer
    - It might have a jumper to set the mode to 0-10v
    - it might be a setting to allow it run off 0-10v
    - It might need an extra relay for an Enable signal (DCM to FOR on the Haunyaung VFDs for example) N
     
  3. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    15,010
    Likes Received:
    4,304

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice