Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Pre black box control help

Discussion in 'Laser Cutters' started by Mike Gonzalez, Dec 2, 2020.

  1. Mike Gonzalez

    Mike Gonzalez New
    Builder

    Joined:
    Nov 21, 2018
    Messages:
    30
    Likes Received:
    7
    I have the MB that came with the Lead1010 at launch, not sure ahat it was called

    Can anyone point me to instructions on how i would wire up a laser module to that MB cor power control, and on/off

    Maybe firmware setting too

    TIA
     
    #1 Mike Gonzalez, Dec 2, 2020
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    14,918
    Likes Received:
    4,291
    Firmware: Read gnea/grbl
    You can load the BlackBox profiles to an xPro too - similar enough


    Almost the same as BlackBox: PWM and GND into the control signals of the laser, and provide power to the laser into its power terminals
     
    #2 Peter Van Der Walt, Dec 2, 2020
  3. Mike Gonzalez

    Mike Gonzalez New
    Builder

    Joined:
    Nov 21, 2018
    Messages:
    30
    Likes Received:
    7
    Thanks

    Can you direct me to a pinout of that MB that shows which connections im looking for

     
    #3 Mike Gonzalez, Dec 2, 2020
  4. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    14,918
    Likes Received:
    4,291
    #4 Peter Van Der Walt, Dec 2, 2020
  5. Mike Gonzalez

    Mike Gonzalez New
    Builder

    Joined:
    Nov 21, 2018
    Messages:
    30
    Likes Received:
    7
    #5 Mike Gonzalez, Dec 2, 2020

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice