Afternoon all - In the final set up stages of my new interface. I cannot seem to get my xyz probe plus to run from the interface. I did load the required drivers from open builds >thumb drive>Interface. What am I missing here?
I am not in alarm mode. I manually set zero and attempted to run the job. Ran without an issue. When I use the XYZ, I get the following message (pic also attached) Running: /PROBE/PROBEXYZ.0.00% Sending:
Are you on latest firmware? v1.43 docs:interface:firmware-error-partitions [OpenBuilds Documentation] Did you use CONTROL v1.0.275 to create the Drive? docs:interface:prepare-usb-drive [OpenBuilds Documentation] Did you edit the Probe Macro files by hand perhaps?
I have to go pick up a USB-c data cable to load v1.42 directly off of open builds control. I think that this might be my issue
