Hello, I need your advice because I didn't succeed to slightly rounded and cut at the same time the sides of a plate. When I do it, the size of the cut is a little bit smaller than asked. The thickness of the plate is 3mm and I use the CMT 765.402.11 router bit (Fraises profilées | CMT Orange Tools). Here are my settings in OB Cam. Thank you.
Post a pic of the result please? Your screenshot shows a 10mm endmill diameter entered. Is that correct? Wouldnt you want the offset from drawing to be the thinnest section of the bit?
Peter, Your answer lets me think that indeed I made a mistake with the diameter I'll test it tomorrow. Thank you
