I wired my limit switches as per the instructions here (so I can have a limit switch at the min and max point of the axis) docs:blackbox:connect-xtension-limit [OpenBuilds Documentation] And they do not work - however if I disconnect one limit switch then the other one will work. I'm sure I'm doing something incredibly simple wrong, but I can't find out what the problem is - has this happened to anyone else before?
both switches must be wired to the 'NO' Normally Open contacts. use the OBControl diagnostics to check switch status, each switch by itself, and then pairs wired together.
Use our switches Xtension Limit Switch Kit See docs:blackbox:connect-xtension-limit [OpenBuilds Documentation] Our official switches are just easier as all the labelling matches and they were designed to be used that way with ease Those ones you have may be NC instead of NO (you'd have to figure out) and thus cannot simply be wired together in parallel. You'd have to wire them in series, or modify them etc.
