Welcome to Our Community

Some features disabled for guests. Register Today.

Wavy Cnc 1010 router cuts

Discussion in 'CNC Mills/Routers' started by themac333, Mar 3, 2022.

  1. themac333

    themac333 New
    Builder

    Joined:
    May 19, 2021
    Messages:
    1
    Likes Received:
    0
    I’m making a sign made from 3/4 pvc board with a 60 degree V bit on my cnc 1010 machine, I’m trying to figure out why the edge cut are wavy and not smooth, I attached a photo
     

    Attached Files:

  2. Giarc

    Giarc OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jan 24, 2015
    Messages:
    3,008
    Likes Received:
    1,676
    Did you do a roughing pass and then a finishing pass? I usually will do a roughing pass and leave about 0.3 mm for a full depth finishing pass to get a better edge finish.
     
    Peter Van Der Walt likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice