Welcome to Our Community

Some features disabled for guests. Register Today.

XYZ Probe Stuck at Z

Discussion in 'CNC Mills/Routers' started by Wendel Clement, Apr 8, 2023.

  1. Wendel Clement

    Builder

    Joined:
    Mar 19, 2023
    Messages:
    91
    Likes Received:
    4
    New Installation, I have set up my XYZ Probe out of the box. But when I try to probe in the automatic mode it comes down on the Z, gives the green light and then gets stuck there. If I try the other mode it goes past the plate and starts going down into my material.

    I've check through the Forum but can't seem to see this scenario. I am running the X32 Controler all out of the box and being used for the first time.

    Any ideas?
     
  2. David the swarfer

    David the swarfer OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Aug 6, 2013
    Messages:
    3,435
    Likes Received:
    1,908
    You need to update the firmware in the X32. Use OpenbuildsCONTROL to do it.
     
  3. Wendel Clement

    Builder

    Joined:
    Mar 19, 2023
    Messages:
    91
    Likes Received:
    4
    Thank you, will do.
     
  4. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    14,921
    Likes Received:
    4,291
    Step 7.1 of the BlackBox Documentation at https://docs.openbuilds.com/blackbox-x32

    If you did skip the docs, also make sure to see section 4.2 (another important step best followed)
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice